Solar power perimeter break alert sensor Package including:
1pair triple beams solar-power 100m beam sensor T001-Q3
1set multiple wireless receiver with 4 zones wired output HB-MFR (with 1 pc power adaptor, 1 pc remote controller)
Very easy and fast to install, ideal for protecting Perimeters,Entrances, large Remote Buildings.
These unique Perimeter Beams are very easy to install as they have sound and light indicator for power on/off, normally operating, breaking detected etc.
It will make scare alarm sound and send alarm when it is off. It is industry grade high security product and can work at extreme weather condition such as heavy snow, rainy days.
Details as below:
Solar Powered Triple Beams Wireless 100m Active Wall Light Perimeter fence.
Updated with electricy power supply and battery rechargeable power jack.
Specification:
Distance: 100m
Wireless Transmitting Distance: 100m
Wireless Transmitting Frequency: FM: 433MHz
Maximum alarm times in 24 hours: Not more than 50times.
Battery Capacity: 500mAh (Transmitting terminal), 1000mAh (Receiving Terminal)
Working environment temperature range: -30C~70C
Number of beams: 3 beams
Operating Voltage: 3.3V
Static Operating Current: Transmitting terminal<=0.5mA, Receiving terminal<=0.5mA
light frequency: Secondary moudulation & encoding based on 38KHz
Light wavelength: 940nm+/-20nm
Solar electric panel output current: >=2mA at light intensity of 1800LX (note: the outdoor light intensity in cloudy or rainly days is about 2000LX)
Dimension of product: 340mm*50mm*84mm of Receiving terminal, 340mm*50mm*45mm of transmitting terminal
Precautions:
1.Never install the beams at an inclined angle.
2. Make sure that there is no obstacle between the transmitting terminal and the receiving terminal.
3. Use multiple beams for long distance to avoid mutual interference among beams.
4. Keep the in-frared light hole-posed to direct sunlight.
5. The high-voltage tower and the signal tower may influence wireless transmission distance.
6. Never install this beams near door access systems, passages, areas prone to trigger an alarm or areas which could trigger an alarm more than 50 times per 24 hours.
7. This product is a solar powered wireless product, so it shall not be installed, tested or operated indoors or in any dark place with a sunlight intensity of less than 2200 lux.
8. This product can trigger an alarm less than 50 times when it is tested under normal sunlight conditions. Never try to test maximum alarm times indoors.
9. Never put the multi-beams light wall in any dark place or cover the solar panel with any material at power-on, otherwise, the product may not be normally powered on.
Wireless receiver and transfer to wired third party alarm host HM-MFR
1.It is used with HB brand solar powered wireless perimeter protection detectors.
2.The receiver can equip 4 detectors in 4 zones.
3.It makes alarm sound with 4 different tones (beep, wind-bell, plink, clarino) for 8 seconds.
4.It has 4 form "c" relay output terminal for 4 zones.
5.It has 14VDC output for wired siren.
6.Output relay and 14VDC terminal can activate for 1 second, 10 seconds, 1 minute or 5 minutes.

Specification:
1.Frequency: 433MHz
2.Operating voltage: 15VDC (power adapter is supplied with the package)
3.Operating current: standby 20mA, Alarming 180mA
4.14VDC terminal output current: 400mA maximum
5.Relay rating: 24VDC or 120VAC at 2A